For all points Y0, the center of the probe is off the build plate by about 1.6in. When hotend #2 is selected and the DSE is moved to Y-home it pinches the cables for hotend #1 against the wheels on the Z-axis rollers and bracket with no where else to run them. The Y-home position is not mechanically adjustable like the X-axis and I can't see how software tweaks would help so I'm at a loss for how to fix this issue. Ideas are appreciated.
top of page
To see this working, head to your live site.
DSE Hotend #1 hits Z-Axis roller bracket at Y-Home
DSE Hotend #1 hits Z-Axis roller bracket at Y-Home
1 comment
Like
1 Comment
bottom of page
The DSE hotend cables should be cable tied to the DSE backplate, so shouldn't hit the rollers when homing Y. With Hotend 2 selected and Y-homing that Hotend 1 cables do touch the Z-axis bracket, but this is ok. In most cases you should be homing with Hotend 1 selected, Hotend 1 is the primary hotend and if your doing a single hotend print it is recommended to use hotend 1 for it. Could you please upload an image of your set-up, it may just be an issue with cable routing.