I have started to print the test structures from Make:
That shows different problems of my printer.
The gantry is not perpendicular to the X-Axis which I see in the print and also looking from above. The Z-Pillar seems do be quite ok. So it is probably the guides of the gantry on the Z-Pillar.
Is there a recommended way to correct this?
The Z-Axis wobbling test shows a sine wave of the tower in Z direction especially on lower layers.
What does this mean?
@Gareth Owen i know this sounds obvious but that looks like the filament is too hot and not issues with over extrusion. Have you checked the thermistor is shoved all the way in the little hole as far as possible.
This was exactly problem i was having with my prints. As soon as i checked this and corrected the location my prints were 100 times better. also my temperature fluctuations have decreased massively now.