Hi all,
im kinda noob but i noticed while printing bed level test squere that my nozzle moves like this- extrudes a line, stops extruding, moves back on top of the extruded line to the beginning and then goes and extrudes another line 🙄.
I allways thought that its should be Zig-zag- extrudes one line, and as the nozzle is coming back, extrudes antoher to the side of the first one. like in the pic.
Mine goes like this, as described before, sry for the awsome focusing skills my phone has.
So my question is, is this normal or i have thicked some box somewhere?
regards,
J. Helm
Update, swap my nozzle to 0.8 did couple of test runs, found cura settings- top/bottom pattern where u can swap between lines/zigzag/cocentric. And i guess i had a bit of a overextrusion problem that squeezed fila to the oncoming path, making it hard to see the zig zag motion.
case closed.