Hi All, its been a relativity painless build so far but i do have some guide tweaking to do ill reed up on that later.
what is really bugging me at the moment is no mater what i do i can not get the Model to Stick to the plate. I`m using the PLA+ supplied in the kit and i have the Flex Plate upgrade. the base of the Model prints OK , then when the actual Model is being printed it the base comes loose from the flex plate then its all over the place with the head moving the Model.
So far i have tried PritStick (one person mention) but it still does not stick. what am i doing wrong :(
This is my fist 3D printer so please bear with me.
Hi, thx for the replies :)
I have found out the reason , the base layer is sticking to the plate (with PritStick)
The actual issue is the Z axis movement , it is not moving up in small movements , but will with large movements so the print head is crashing into the model. Ill look at the forum for Ideas as its the old alignment issue .... erghh