I am at stage 9, step 26: extruding. The hotend does heat up to 200 degrees and everything seems to work. However, when i press extrude no filament comes out. It seems that neither of the 2 motors are responding. Does anyone have the same issue?
top of page
To see this working, head to your live site.
1 Comment
bottom of page
Are you using Pronterface? Check to see if you're suffering from this issue: https://www.forum.makertech3d.com/forum/axis-3d-printer/error-all-low-and-error-printer-halted-kill-called
What stepper drivers are you using? 2208's on the X,Y,Z and the A4988's on E1 & E2? Double check that you have the correct stepper drivers selected in Configuration.h, that the jumpers on the board are in the correct position for the type of driver in use, and also that the stepper drivers are inserted correctly.
I'm wondering if there were bad stepper drivers in the kits. I tried re-using the ones that came with my kit when I had to switch mainboards but was having a problem with them; I got TMC connection issues. I have all TMC2209's in and there hasn't been an issue.