Copyright © Makertech 3D Ltd. 2019 - All Rights Reserved. - U.K. Company No. 10715504 - U.K. VAT No. GB 273781181

Leave feedback on your web experience here.

  • White Facebook Icon
  • White Twitter Icon
  • White Instagram Icon
  • White YouTube Icon

Contact Us

Terms & Conditions

Privacy Policy

About Us

Attributes

Press Room

  • STORE

  • FORUM

  • RESOURCES

  • CONTACT

  • More

    Return To Mainsite
    1. Makertech Forum Home
    2. Assembly
    3. 3010 extruder fan cracked
    Search
    Timothy Stark
    Apr 29

    3010 extruder fan cracked

    1 comment

    Since I am almost finishing my 3D printer build, I assembled extruder parts together. I attempted to install one of DSE extruder fans and it got cracked. I just finished one extruder assembly so far but hold on other due to cracked fan for now. I was looking for a replacement but can't find specific model through some vendors like 3010 24v fan with 2m (200cm) cable. I now had to submit form for replacement but it takes some time.

     

    Does anyone know vendor like Amazon sell that part (3010 24v fan w/2m cable)?

    0
    Makertech
    Apr 30

    We've got your order for the replacement fan and should be with you soon, but the fan is 5015 24V if you want to source it locally.

    0
    New Posts
    • Mark Perry
      Oct 12

      No Connection or lights when connecting to USB

      Hi, I am attempting to complete Stage 10 Step 7. When I connect the control board to the computer USB port, I don't get any lights and the port doesn't show up in Arduino. I have tried 2 different computers, I have also tried connecting directly with the blue cable into the control board, rather than through the extension cable. With the same result. No lights showing. Directly connected and no lights. If anyone has any ideas I would appreciate trying them.
      0 comments
      0
    • xecaz
      Sep 30

      Missing temp readings and heat on extruders and bed

      I am building the Proforge 2S with dual extruders and the heated bed upgrade and at stage 10, step 15 (https://makertech-3d.dozuki.com/Guide/Stage+10+-+Programming/15?lang=en) i see all 3 icons(heated bed, and both extruders) but only Extruder 2 shows the correct ambient temprature. Extruder 1 shows -15c and the heated bed show 166. To verify that the thermistors are working i tried to connect each and every one of them to the Extruder 2 pinout on the board and they all show their respective ambient tempratures, confirming that the thermistors work individually. However no matter what thermistor i connect to the other 2 connectors on the controller, i get no other reading. Do i have to enable something in the arduino code to enable the other ports on the controller? Someone suggested to swap the polarization of the sensors, but this left me with the same result. Additionally preheating the bed or any of the extruders does not change their temprature (using my fingers to feel if they get warm). I measured the powersupply and see good voltages. Has anyone else ran into this?
      2 comments
      0
    • FM
      Sep 9

      Dead servo

      Look like I've got a dead servo. Tests failed on DSE Stage 07 - Switching Arm and Z-Offset I'll arrange for a replacement.
      0 comments
      0
    • Black Facebook Icon
    • Black Twitter Icon
    • Black Instagram Icon
    • Black YouTube Icon