deró
Apr 12, 2019

Dual extruder/solenoid

Installed the Dual touchscreen and Marlin, configured the solenoid to switch hot ends, then verified both extruders worked. While testing #2 extruder, the solenoid started to buzz and now it will no longer respond. Looks like it has failed, hopefully not the driver board.

0 comments0 replies
New Posts
  • manormews1
    3 days ago

    Hothead #1 heats up as soon as power on.

    Question 
    Hi, Hothead #1 heats up as soon as power on, raises to 270C won’t tuen off and can’t control via touch screen. Hothead #2 working fine as is bed. Any pointers. James
  • itsmejun
    Jan 22

    TMC2100 and A4988 stepper driver

    Discussion 
    Is anyone upgrade TMC2100 to TMC2130 or TMC2208. Please advice me adjusting a trimpot from TMC2100 to TMC2130 or TMC2208. And it is ok to upgrade?
  • itsmejun
    Jan 15

    Servo direction

    Discussion 
    When I first installed the arm, everything worked for maybe about 30 minutes. Now, when I power it up, the arm doesn't move at all on power up. If I choose to move the arm to hotend 2, it works just fine, but if I try to move back to 1, it doesn't move. And now it is dead. So I got a servo from RC car fortunately, fixed the angle problem to changed the configuration.h, it works fine but opposite way. When I choose 1, it turned left. Is there configuration reverse code can change the servo direction?