Raphael
Apr 4, 2019

Fan on dual extruder

at my printer the fans which are turned on with the software (one the touch screen) are not working, seems like they dont get a signal at all, does this occur to someone else aswell or is ity only me?

1 comment3 replies
Makertech
Apr 4, 2019

Can you plug one of the fan cables in directly (with out the adapter) and see if it turns on then?

0
Raphael
Apr 4, 2019

yeah but it still does nothing, the fans are spinning if i plug them in the base fan slot where there are i think 12V all the time on, then bnoth are spinning so it is not a fan or adapter problem, it is either a program or a mainboard problem i think

0
Makertech
Apr 14, 2019

@Raphael Sounds like it was a mainboard problem, we'll get a replacement sent out to you.

0
Raphael
Apr 25, 2019

@Makertech I got the replacement yesterday and tested it, it worked as it should thanks for that

0
New Posts
  • itsmejun
    3 days ago

    TMC2100 and A4988 stepper driver

    Discussion 
    Is anyone upgrade TMC2100 to TMC2130 or TMC2208. Please advice me adjusting a trimpot from TMC2100 to TMC2130 or TMC2208. And it is ok to upgrade?
  • itsmejun
    Jan 15

    Servo direction

    Discussion 
    When I first installed the arm, everything worked for maybe about 30 minutes. Now, when I power it up, the arm doesn't move at all on power up. If I choose to move the arm to hotend 2, it works just fine, but if I try to move back to 1, it doesn't move. And now it is dead. So I got a servo from RC car fortunately, fixed the angle problem to changed the configuration.h, it works fine but opposite way. When I choose 1, it turned left. Is there configuration reverse code can change the servo direction?
  • Mark Perry
    Jan 15

    No Connection or lights when connecting to USB

    Discussion 
    Hi, I am attempting to complete Stage 10 Step 7. When I connect the control board to the computer USB port, I don't get any lights and the port doesn't show up in Arduino. I have tried 2 different computers, I have also tried connecting directly with the blue cable into the control board, rather than through the extension cable. With the same result. No lights showing. Directly connected and no lights. If anyone has any ideas I would appreciate trying them.