DSE Stage 7 - step 13+14
I may have a problem finding the centre of the platform for both X and Y.
Also the auto-levelling goes about 2cm off the platform (left side + frontside)
It looks like it's rather the probe which levels above the centre of the platfor instead of the nozzle.
It also looks as if the centre of the platform comes a tiny little higher than the 4 corners. Not problematic during auto-levelling, but not sure if this is ok... It looks as if the platform is not 100% flat... Should I be worried?
As far as I can tell, the offset is fine, the probe is looking for where the nozzle will end up for the auto-levelling. The platform being slightly warped shouldn't cause too many problems. I printed about 4KG of filament with my original warped plate - about 1.5mm higher in the middle than the corners, and it was mostly fine when I used a raft to offset some of the first layer problems that the warping caused.