I need to lower the probe quite a bit and already took out the filament heater part of the gantry for better access. But the second, upper screwing element for the probe is still hidden. Do I have to disassemble the printer to lower the probe or is there another smart trick that I have not thought of?
top of page
To see this working, head to your live site.
1 Comment
bottom of page
Did you assemble the dual extrusion head? I didn't have much problems accessing the probe. The only problem was that I did tighten the cables/sleeve too much and so setting the probe lower later on was a bit tricky Make sure you have enough cable loose!