Dan Theman
Apr 8, 2019

Stage 4 Step 9

when I opened the packages for the hot ends this is what I found.

 

 

 

It doesn’t look like anything I should go forward with. any guidance here is appreciated.

This is the heater cartridge wire.

 

2 comments0 replies
Dan Theman
Apr 10, 2019

So when I replace this do I want to get a 12 or 24 V wire?

0
Makertech
Apr 14, 2019

@Dan Theman We've gotten your request for a new heater cartridge, replacement should be with you soon.

1
New Posts
  • manormews1
    5 hours ago

    Hothead #1 heats up as soon as power on.

    Question 
    Hi, Hothead #1 heats up as soon as power on, raises to 270C won’t tuen off and can’t control via touch screen. Hothead #2 working fine as is bed. Any pointers. James
  • itsmejun
    4 days ago

    TMC2100 and A4988 stepper driver

    Discussion 
    Is anyone upgrade TMC2100 to TMC2130 or TMC2208. Please advice me adjusting a trimpot from TMC2100 to TMC2130 or TMC2208. And it is ok to upgrade?
  • itsmejun
    Jan 15

    Servo direction

    Discussion 
    When I first installed the arm, everything worked for maybe about 30 minutes. Now, when I power it up, the arm doesn't move at all on power up. If I choose to move the arm to hotend 2, it works just fine, but if I try to move back to 1, it doesn't move. And now it is dead. So I got a servo from RC car fortunately, fixed the angle problem to changed the configuration.h, it works fine but opposite way. When I choose 1, it turned left. Is there configuration reverse code can change the servo direction?