Return to Forum
Return To Mainsite
To see this working, head to your live site.
  • Categories
  • All Posts
  • My Posts
Arjen Smit
Jul 29, 2020

Extending heater cartridge and thermistor

in AXIS 3D Printer

When extending the cables is it required to use the specific AWG values for each cable or is it just a minimum to be used. The guide says use AWG24 & AWG28 I converted that to mm2 and got 0.50 mm2 and 0.35mm2 (I really hope that is correct). so the question would actually be can I use 0.50mm2 for both?

1 answer0 replies
0
2
Adrian Costa
Best Answer
  ·  Jul 31, 2020

i personally used whatever cables i had laying around they were from an old computer power supply and they seem to be working fine i think its 18AWG

1 comments

Copyright © Makertech 3D Ltd. 2020 - All Rights Reserved. - U.K. Company No. 10715504 - U.K. VAT No. GB 273781181

Return to main site here.