When I type M280 P1 S175 into the terminal, the left hotend is active. For M280 P1 S10 the left. But when I type T0 the servo always switches to the right hotend even though T0 is the left. In marlin I entered 175, 10 at Switching_Nozzle_Servo_Angles but T0 and T1 are somehow swapped. What have I done wrong?
top of page
To see this working, head to your live site.
T0 and T1 commands reversed
T0 and T1 commands reversed
2 answers0 replies
Like
Comments (2)
bottom of page
Apologies, after investigating this further the build manual needed an additional step, please see below:
https://makertech-3d.dozuki.com/Guide/Stage+05:+Firmware+(Klipper)/115#s1321