after setting up using the instructions for klipper when i type t0 or t1 the servo always moves tot he same hotend. using install arm will send it to 90 degrees but it is not moving to 10 degrees when i say t0. any one have a fix for this
top of page
To see this working, head to your live site.
t0 t1 command always switching to the left hotend (klipper)
t0 t1 command always switching to the left hotend (klipper)
10 answers0 replies
Like
Comments (10)
bottom of page
Apologies, the build manual needed an additional step, please see below:
https://makertech-3d.dozuki.com/Guide/Stage+05:+Firmware+(Klipper)/115#s1321