Proforge 2s with DSE.
Got a successful print going with help from the settings in https://www.makertech3d.com/forum/first-print/settings-to-improve-the-printing. I think my heated bed is bowed (arrived that way) so it doesn't contact the bed plate correctly, so the higher temps help. I'll get it replaced soon.
I had lots of issues with head oozing, so I added retraction (used cura defaults - 7.5mm I believe), and Z retract between layers a couple of mm, as clumps of ooze kept destroying the first layer. I think also initial issues with adhesion wasn't helping.
I need to calibrate the DSE X/Y and figure out how to change filaments/heads (guide?) next.
Now, my only outstanding issue is I can't use the provided SD card and touchscreen to print. Direct with Cura works fine (blue) but with the SD reader (red) it stops part way either parking the head or just stopping (mid print). The touch screen continues counting, but progress of course stops. I can cancel the print etc using the touch screen. I tried the left and right shrouds separately to see if it changed anything but nope. Weird.
All in all, mostly happy.