When running the Auto Level i have gotten it to succeed at least once. I then had to remove the bed to fix an issue with the heating element adhering to the build plate. Now with the Flex plate on the build plate when the auto level is running it checks the center, moves to the left closest position to the front of the machine it goes down and then stops. What is causing it to stop rather then continuing the auto level?
top of page
To see this working, head to your live site.
3 Comments
bottom of page
Do you happen to have the dual extruder? The dual switching extruder is physically larger and the position of the proximity sensor is more offset. The offset proximity sensor on that hotend setup over shoots the edge of the build platform causing the auto level to fail. This needs to be fixed in software