When start my printing with the suggested settings the printer is starting with the auto leveling and the first printing, but the filament isnt sticking to the bed properly. After around ten minutes the hotend is starting to get colder an then just stops working and doesnt start again. what can i do to change that?
top of page
To see this working, head to your live site.
4 Comments
bottom of page
Make sure you have a gap between the heatsink and heater block.
Also check your connections at the electronics board.
If you're sure everythings connected properly, you may have a broken thermistor.
If your platform is hitting the physical bolt on the platform, move the endstop trigger a little to the left, assuming your endstop is being triggered (green light).
but now the printer doenst always find the x endstop and when it is moving away from it, its often hots the physical x endstop.
Do you have the black silicone sock installed over the hotend? If the heater cartridge and thermistor secured properly?