Hey everyone, everytime I start to print, either the offset doesnt seem right and it begins to slide across the bed, or it tries to dig in. My print bed is slightly warped, but it heats a little bit. Is this what is causing my print to slide around?
top of page
To see this working, head to your live site.
2 Comments
bottom of page
It's exactly like my problem here: https://www.makertech3d.com/forum/first-print/nearly-perfect-first-layer-but
The offset for the Z-height is set in Cura and should be adjusted in small 0.1mm (or even 0.04mm at the lowest) increments. Check also that your probe is secure. Another thing to try is also removing the springs from the platform and fixing the platform directly onto the stand-offs. Turning the heated bed off may also help as you dial the offset it.
Also the new platform is now available for pre-order:
https://www.makertech3d.com/forum/announcements-releases/new-heated-print-platform