Hi together,
I am having the problem, that the printer stops on random layer changes for a few seconds which is causing blobs... On the benchy the problem gets worse the smaller the layer is.
One time the printer stopped completely...
Any suggestions?
I have got kinda the same problem with the blobs, but in my case its with my second extruder, the first one prints pretty normal no blobs or anything like that an when i printed the benchy with the second extruder there where blobs all over the model and he even stopped before the print was finished and rebooted. I dont think it would be a problem on the SD card bc then my first extruder would have the same blobs. As far as i have read in this post this will resolve atomatically and there is no proper way to solve this problem?