Return to Forum
Return To Mainsite
To see this working, head to your live site.
  • Categories
  • All Posts
  • My Posts
Lee Hamilton Cooper
Dec 20, 2020

Alu Bed levelling - Octoprint Bed Visualiser

in General Discussion

Think I need to adjust that corner, although all the mounting screws are pretty dam tight. Any advice on trying to level out that corner?


2 comments
0
Makertech 3D
Dec 22, 2020

Auto-levelling should be bale to compensate for that corner, however loosening that corner may help. Also adding springs to each corner so you have room to adjust each corner, up and down, is also an option.

0
Lee Hamilton Cooper
Dec 22, 2020

Thank you. tbh there wasn’t much of an issue anyway, it was just my OCD telling me there was something substandard and an area that had the possibility of improvement. I tried loosening the corner, but something in my mind didn’t like that concept, so when it returned with very little effect I went exploring other alternatives. Found another post on this forum about Babystepping and configuring UBL as an alternative to linear bed levelling, which had actually improved something that was good already. So bonus!

0
2 comments

Copyright © Makertech 3D Ltd. 2020 - All Rights Reserved. - U.K. Company No. 10715504 - U.K. VAT No. GB 273781181

Return to main site here.