Is it possible to factory reset the software? Everything was fine yesterday, but then this morning when I turned on my printer, it is showing Hotend 1 at 154 degrees, Hotend 2 at 21 degrees, and the Heated Bed at -15 Degrees, with the Fan Speed at 0. That is obviously incorrect. I checked the wiring to make sure nothing came unplugged. Any thoughts? @Makertech have you experienced this before?
I'm trying to raise to 130° (planning to print pom-c) but it goes up to 100° and then stops: (Error: Heating failed, system stopped! Heater_ID: bed - Printer halted. kill() called!) Has anyone tested the max temperature heated bed can reach?
It's due to hardware limit?