Alexander Schönbohm
Dec 8, 2019

Proforge Marlin Update to 1.1.9

Hi all,

 

I have one of the first kickstarter Proforges and I wanted to switch to Marlin 1.1.9 and after sorting out the config I have the issue that the printer stops repeatedly during printing via Octoprint . It seems to me that the printer is waiting for commands from the octopi, the terminal window showed the following error message:

Communication timeout while printing, trying to trigger response from printer. Configure long running commands or increase communication timeout if that happens regularly on specific commands or long moves.

Recv: Error:checksum mismatch, Last Line: 165

This never occured with the stock marlin version.

1 comment0 replies
Makertech
Jan 15

Is this on a Proforge Original? First thing to check would be if the baudrate value from the firmware matches with whats set in octoprint.

0
New Posts
  • Willy Duffle
    Dec 22, 2019

    Marlin 2.x

    Discussion 
    Has anyone attempted an upgrade to Marlin 2.x on the 2S yet?
  • Willy Duffle
    Jun 16, 2019

    Hotend_Offset_Y

    Discussion 
    Has anyone had issues getting the y-axis offset calibrated on the dual head extruder? My single material prints are beautiful but the second nozzle is about +1mm off in the y and I have tried modding the offset in the firmware by 2mm and it is still the same, like it had little to no effect. Is there anything else I have to adjust to make it take? I already adjusted my z-offset with great success.
  • deró
    Apr 26, 2019

    Touch panel display

    Discussion 
    Is there any way to configure this to display current activity? As in showing X,Y and Z position and possibly Layer height, plus fan and temps? After setup, it is fairly useless during printing. My other printer uses Ramps and larger display, the active print info is displayed.