Is there any way to configure this to display current activity? As in showing X,Y and Z position and possibly Layer height, plus fan and temps? After setup, it is fairly useless during printing. My other printer uses Ramps and larger display, the active print info is displayed.
Search
New Posts
- DiscussionHi all, I have one of the first kickstarter Proforges and I wanted to switch to Marlin 1.1.9 and after sorting out the config I have the issue that the printer stops repeatedly during printing via Octoprint . It seems to me that the printer is waiting for commands from the octopi, the terminal window showed the following error message: Communication timeout while printing, trying to trigger response from printer. Configure long running commands or increase communication timeout if that happens regularly on specific commands or long moves. Recv: Error:checksum mismatch, Last Line: 165 This never occured with the stock marlin version.
- DiscussionHas anyone had issues getting the y-axis offset calibrated on the dual head extruder? My single material prints are beautiful but the second nozzle is about +1mm off in the y and I have tried modding the offset in the firmware by 2mm and it is still the same, like it had little to no effect. Is there anything else I have to adjust to make it take? I already adjusted my z-offset with great success.
Not currently, but we'll try and look into it if possible.
There also seem to be issues when using the touchscreen while printing over USB.
The touchscreen seems to be talking the the main board via usb, just like Cura, if you usb print. The buttons on the touchscreen map to Gcodes, ie G28, home all. If your not printing both paths work, but if printing, I believe your “job” fills the buffer. Haven’t tried changing hot end temps during a print, this works on the Ramps board and screen.
Changing temperature leads to negative numbers on the touchscreen for example. Sometimes... 😉