jonroberts87
Apr 15

SD Card Support

1 comment

I have found that the SD card is not naitively supported on octoprint with the current configuration of marlin. Before i enable SD Card Support on marlin is there any reason this was left disabled? If i enable it is there any recommendations for setting the SPI speed?

Makertech
Apr 17

The TFT24 touch screen interfaces through the printer's serial connection, essentially acting as a computer, it does not interact with marlin SD card support. Because of this octoprint would not be able to run with the SD card in the touch screen.

0
New Posts
  • Julien Steines
    Nov 26

    How do I upload changes in Marlin while the Raspberry in mounted?

    I installed the Raspberry and the camera yesterday and I am wondering now how I upload changes in the Marlin Firmware (the probe settings for example) without disassembling the blue USB Cable from the Raspberry Pi.
  • fg
    May 16

    Raspberry camera is shaking

    Hi! Has anyone created a successful timelapse?! Every video I recorded is an absolute mess with blurred video frames due to the fact that the printer/camera is shaking a lot. I even stabilized the camera with another 2020 extrusion on the endstop side of the X axis that enables me to mount the camera directly in the center of the build platform. I thought of creating a kind of gimbal/mechanical stabalizer to mount the camera on but there must be a better solution...? 😉 Thanks!
  • jonroberts87
    Apr 16

    Filament sensor

    So, I just found out the filament sensor does not natively work on the octoprint. Any suggestions on plugins (settings for the plugin) to get that to work?