Return to Forum
Return To Mainsite
To see this working, head to your live site.
  • Categories
  • All Posts
  • My Posts
Mirko Oliver
May 16

Running out of Bounds

in Proforge 3 3D Printing

My Printer keeps running out of bounds when i start a print and I'm unsure why.

I wiped the printer completely, set up both sd cards new several times already, disconected Octopi Upgrade. Reinstalled Cura and set it up as instructed but the problem persists. I'm completely out of ideas on how to get my printer to work.

Also my printer keeps crashing as in the display is just completely non responsive.

2 comments
0
Mirko Oliver
May 18

Also if I do get it working after about an hour the printer seems to forget where it is and again runs out of bounds

0
Craig Petre
May 19

Out of bounds as in it smashed against either side and starts grinding? If that’s the case maybe check the end stops? That they are connected correctly and I think part of the wiki has you verify them from the fw side. Also worth checking the bed size in the slicer and the absolute vs relative positioning in your startup gcode.

0
2 comments

Copyright © Makertech 3D Ltd. 2020 - All Rights Reserved. - U.K. Company No. 10715504 - U.K. VAT No. GB 273781181

Return to main site here.