Hello,
i'm still not done with my pf3 and got a lot of problems with cooling and retraction. My
So i tried to adopt a EVA hotend to the printer. Here i was asking for it: https://www.forum.makertech3d.com//forum/proforge-3-3d-printing/extruder-fanduct-mount-upgrade
I'm not a big designer, but this is the best what was able for me and Tinkercad:
Now i have to realign the Z-Sensor and the available hight. Is it better for me to run klipper? My sd card slot is broken, so it would be better anyway. @Johannes Weis Do you got a working klipper version? How i can adjust it? Thank you for the answers.
Thank you for the answer, i have a mic-6 bed and the casefan installed. So i dont need to change anything?
https://github.com/WunderBertrand/Proforge3_Klipper
There you go. It is a working config but I’d suggest to add whatever you want in addition to the barebones config. A few lines for pause and resume for example. Also change the probe location to accommodate your placement. You should delete the segments for the enclosure fan.
If you have the 24V bed installed you should also check if that section is correct.
As for how to change the config and install Klipper, there should be a how to video linked in the description. Follow those steps and then import and adapt the config.