The left side x axis belt has jumped off the ballrace a couple of times. I did them all up a tight as I could. I might well have overdone it! Is there a more accurate method of getting the correct tension? Also the washers keeping the belt on the ballrace doesn't seem big enough diameter to keep the belt on any fixes or is it just me? Cheers
top of page
To see this working, head to your live site.
4 Comments
bottom of page
My solution was to replace the washer stacks with flanged bearings... Here is my write-up:
https://www.forum.makertech3d.com/forum/proforge-3-3d-printing/upgrade-idler-pulleys