Home for the Z axis does not work.
Can anyone help me how exactly the Home-Z is set.
So far I'm doing this:
- Stepper disable
- Flexplate manual until red light on the sensor
- Minimum down, turn off the light
- Stepper back on
- Press the Z-Home button on the touch screen
Unfortunately, this approach doesn't work.
When I press the home button, the flexplate rises too far and presses hard on the nozzle. I then switched off immediately.
Do I have to or can I reset the setting somewhere? I have the feeling that totally wrong coordinates are approached.
Is there a way to reset all values to factory settings?
Thanks for the help
Hermann
top of page
To see this working, head to your live site.
Homing-Z setting dos not work
Homing-Z setting dos not work
1 comment
Like
1 Comment
bottom of page
When the z probe is triggered (light is on) does it show that when you send M119? Your description sounds like the probe is working, but the board (or firmware) never realizes that fact.
If M119 does not show z_probe triggered, try re-flashing firmware with a new SD card.