Hey all,
I just got my Proforge 3 last week and have been slowly building it. I have the regular 24v Print Bed, but I can't seem to find the power cables to connect the MOSFET to the Power Supply
I'm stuck on step 12
Anyone else figure out where the power cables are packaged?
I've triple checked everything that I've received and gone through all of the packaging multiple times to make sure I didn't accidentally discard it. The power cables are probably just bundled with other cables and I'm overlooking them.
Thanks!
I didn't have them either so I bought them via Amazon. Including the spade connector
I did not find them, however I was able to borrow the ones from my original ProForge 2S.
Fill out this form and Makertech can send you anything you're missing
Did you end up finding them? I had the same issue... fortunately the cables from the bed itself had enough slack that I could cut them to create the power cables.. Hopefully the power cables are also 16 AWG. My thermistor connector was also wonky.. a black connector that doesn't really fit on the controller board.. and god knows what the orientation is. My mosfet and mosfet control cable were also different than the pictures (control cable was all white and the controller standoff was oriented different). I noticed a small + silkscreen on the PCB for the mosfet that I took to mean it matched the red cable from the pictures. More guessing going on here than I'm comfortable with :-/