The wiring on the motor cables does not match the order shown in the photo’s at the motor end(ie they are Red, Black, Blue, Green). The order at the control board matches the photo’s (ie Red, Blue, Green, Black). Are wires sensitive to position in the Connector ? This is the same for the Z axis motors.
top of page
To see this working, head to your live site.
2 Comments
bottom of page
It's ok, the cables differs from the original 3D print built from them.
But everything is ok now in the firmware, before the motors moved wrongly cause of this, or this is what I read here in the forum and in a git hub comment.