Return to Forum
Return To Mainsite
To see this working, head to your live site.
  • Categories
  • All Posts
  • My Posts
Akisame -
Mar 20

Printer not turning off

in Proforge 3 Assembly

ehm....The printer doesn't want to turn off anymore.....

The front button isn't stuck...it isn't over tightened (it is loosely hand tightened). It...just doesn't work anymore....I can press it and it pops out but the printer just keeps going....

Anyone any advice??

2 comments
0
Akisame -
Mar 20

Popped in another momentary switch. It works again. Measured the old one....It is stuck in the open position....

Really disappointed with the quality....

0
Johannes Weis
Mar 21

@Akisame - had this on our two switches as well. Disassemble them with a small screwdriver to get to the clickedyclick bit, click it a few times to get it unstuck, reassemble, done.

2 comments
Similar Posts
  • No Printer
  • Why Proforge 2S Dual. Power just shut off, after printing for about 10min or so, then power restored and the printer rebooted. Thermal cutof
  • Got a Dead Printer

Copyright © Makertech 3D Ltd. 2020 - All Rights Reserved. - U.K. Company No. 10715504 - U.K. VAT No. GB 273781181

Return to main site here.