Return to Forum
Return To Mainsite
To see this working, head to your live site.
  • Categories
  • All Posts
  • My Posts
Peterg
Mar 30
  ·  Edited: Mar 30

Seal the Keenovo edges

in Proforge 3 Assembly

The Keenovo instructions recommend that you seal the edges of the bed heater with high temperature, red silicone RTV/gasket adhesive. Make sure you get it on, under, and around the wires. Seal that edge completely. This helps prevent the heater from coming loose later on. It seals the edges so that it is a lot ikely to get a bubble in the center over time.


1 comment
0
Johannes Weis
Mar 30

Even better: put an adhesive insulation pad over the whole underside of the bed!

0
1 comments
Similar Posts
  • why does the print head go over the edge
  • PI Cam Mount
  • Ensure Print Platform is Level

Copyright © Makertech 3D Ltd. 2020 - All Rights Reserved. - U.K. Company No. 10715504 - U.K. VAT No. GB 273781181

Return to main site here.