Wiring done

Thank you for the help. My wiring is now done also!

Thank you for the answer. I've connected the extruder here: black wire. Is it right?

I would connect the "5V to USB converter" here:

Is it right?

An other question is the position of the jumpers under the blue heatsinks. Is it right in manual?

My board was pre-configured like this:

Thanks a lot!

Hello, i'm on the wiring now.

How i have to connect the "5V to USB converter" to the PSU?

Where i have to connect the extruder wire to the controll board?

Thanbk you for the answer.

That’s my wiring so far, but I'll Solder the cables for the two Z-axis a bit shorter because one of the two came damaged >.<

I ordered without the PI upgrade and used my own and so far, it looks like the board delivers enough power to run the Pi. In a few days I guess I’ll see, how it runs when the second screen is connected :-)

I'll drill a hole then. Seems nicer. Haven't received mine yet btw. I was expecting the firmware to already be done though with 2-3 months of delay....

If you have an M3 nut left over, you can drill a hole. I’ve fixed mine temporarily with zip ties.

What do you recommend? Drilling some mounting holes or double sided tape?