Hi All, so I am having an issue with my bed, it just isn’t flat, if I run ABL it shows that 1 side of my bed is 0.39 mm higher than the other which is a big deviation and is just making it in possible to print. I am not sure why its like this, has anyone had any similar issues? Is it the MIC 6 bed, do I have one Z stepper moving faster than the other? Is something warped? Any help would be great as currently I am out of ideas!
top of page
To see this working, head to your live site.
Edited: Mar 12, 2022
Bed won't level
Bed won't level
12 comments
Like
12 Comments
bottom of page
I'm having bed leveling issues as well.
I purchased an assembled printer.
Almost 2mm from 0/0 to 0/300.
I have attempted to correct with spacers, but it won't work.
The values change, but the skew amount does not.
Has anyone had any communication with Makertech at all on any issue?