Is there a guide to setup PF3 into the new cura 5.0 for Mac?
I tried and improvised with the guide for Cura 4x however landed me in so much mess that I had freshly wipe out both my Cura 4 and 5 and start a new.
So I am now fresh with Cura 5 installed, temporarily using their custom printer setup however I wish to have a tidy Makertech-optimised setup.
I was wondering that too. Presumably copy and paste the start and end g code and copy the other settings?
Is there any difference between the mac and Windows versions of cura, settings wise?
Cheers