Hey guys,
I made a simple klipper config for the DSH.
Feel free to use it.
I've ran a few tests and haven't found anything amiss yet but if you do find something let me know.
Klipper config for proforge 3 DSH
.zip
Download ZIP
thermistor values
.xlsx
Download XLSX
Hi,
I have the feeling the bed mesh is not using the correct correction when printing with the second tool.
Would it make sense to add a "BED_MESH_OFFSET" command to the T0/T1 macros?
I found some discussion about this here: https://github.com/Klipper3d/klipper/pull/4346
Would it be correct to assume the X offset from T0 to T1 would by 28.0mm (found in Marlin firmware)?
As I'm not a Klipper guru, I'm looking for your input.
Saw in the comments of your printer.cfg that you need skew_correction. Out of curiosity what are your values?
Hi, I would be happy to give it a try and help with testing but there are some points I'd like to understand as I'm not familiar with Klipper at all. I've looked at tutorials for installation and it should be no problem.
What I could not really figure out is what will be a typical workflow from Cura to a started print. My current workflow is load stl file => slice in Cura => send to OctoPrint => start the print from OctoPrint.
Do I need to keep OctoPrint to get integration with Cura? I don't want to move around with SD cards or have many steps to start printing.
Will OctoPrint interfere somehow (e.g. slow down) with Klipper?
Would Mainsail or Fluidd replace Octoprint for Cura integration and printer control?
I assume one would loose the nice user interface on the printer screen, right?