Return to Forum
Forum Comments
Gantry hits physical barrier before hitting Y-endstop
In AXIS 3D Printer
David Donaldson
Jul 30, 2020
I ran into the same problem. Switched the eccentric guide with a fixed one, still not enough. I just pasted a chunk of plastic on the Y guide so that it would hit the switch sooner
2
0
Z sensor not triggering
In AXIS 3D Printer
David Donaldson
Jul 29, 2020
Best Answer
OK, fixed my own problem. Everything was wired properly, but the mains were not fully seated. This was the first test that required the 24 volts to be active. Once I got the mains fully seated it started working as expected
1
0
David Donaldson
0
Followers
0
Following
Follow
Following icon
More actions
Profile
Forum Posts
Forum Comments