1. The hotend 2 red wires and white thermistor wires are nowhere near long enough and I definitely have the wire pulled through the webbing correctly. 2. The hotend fan cable has a white attachment on the end so I need advising if to cut this off so that I can join the wires with the others or not? 3. I have 2 extruder motor cables and only one is described in the instructions, so where does the other one plug in? 4. I only have 1x 1m motor cable left instead of 2 x50cm motor cables that I need to connect the 2 motors underneath the base. I have taken photos that correspond to these problem if you can provide me an email address to send them. Thanks,