What are you trying to come up with?

What seems to be the problem or problems we seem to have a few guys on here that are helping myself including even though michael seems to be way ahead of myself in improving this printer

Managed to print one of these off today thanks to you guys slightly messed up on the top but I think my tip was to close to the bed but it should do the trick I think

hey, thanks for the reply. yes I’m going to start on the upgrades myself I just wanted to get it as best as I could before adding upgrades. the rail is definitely a need I think to make sure it dont drop when the heads at the front. I think I’m going to change the temps a little and also do the bed level, paper test and cheek how much the filament is taking again to double cheek. while I wait for the bearings to arrive

yes i also undone hot end about 1 turn and push the tube in all the way and then re tighten it up

how far is your tube pushed in? other thing is how far from the bed is the end?

hey i love the design did you upload the files anywhere?

great work guys i am at the same stage of making the printer better. the bed levelling seems to be my biggest issue.

i am on the upgrade steps. whats the first things you would recommend. im not happy with the bed as it seems to really drift from the front to the back.

it may be my fault i left it over night in my office and it was super hot in here. found having the air con on seems to help. But its getting there still lots of work. just printed the shroud off to see if that helps.

@Pritesh oo how do you do that, also are you using the version they said to use or the official one?

i know that feeling all week ive been trying to get mine to print building it wasn't the problem im at the hardest part now sadly

ive defiantly had Grinding Filament and i would say ive got Over-Extrusion do you recommend swapping to that slicer?

i seem to have fixed mine there should be a pin gap between the to cables

i had this turns out the grey cables needed the black bit cutting off as they was the wrong way around.