Forum Posts

deró
Mar 06, 2020
In Dual Switching Hotend v1
Multi hour print failure, luckily soon in. The Kickstarter promised silicon pads, tape is not a good solution.
#1 bitch about the DSE..... content media
0
1
113
deró
Jul 26, 2019
In General Discussion
Any update or timeline for an official release?
1
6
91
deró
May 14, 2019
In Dual Switching Hotend v1
The teflon tape is not a good long term solution for stopping oozing of the second extruder. Balls form and can dislodge the print. The tape tears and can get caught up in the print. The Kickstarter info promised silicone Pads?
Silicone Pads content media
0
1
91
deró
Apr 17, 2019
In Dual Switching Hotend v1
Hi Bought this one off Amazon, RoboJax MG996R Metal Torque Gear Digital Servo Issues: The back side chrome screw heads are bit large, I had to file the DSE hole larger. The cable connector different type, modified to fit. Irritating, the brass gear was bit larger, had to heat up the bearing lever to press fit. So DSE backup at this point (bed level issues, so still not actually printing models yet)
1
0
82
deró
Apr 15, 2019
In Hardware Components
Curious what this material is? I haven’t tried PLA on it yet, but it’s a disaster with PETg, removing the print either destroys the item or tears up the sheet. Previous been using BuildTak, works well with PETg.
0
2
99
deró
Apr 14, 2019
In Marlin Firmware
Is there any way to configure this to display current activity? As in showing X,Y and Z position and possibly Layer height, plus fan and temps? After setup, it is fairly useless during printing. My other printer uses Ramps and larger display, the active print info is displayed.
1
4
87
deró
Apr 13, 2019
In Assembly
This is weird, I assume it is to do with the magnets stuck under the heater plate. I spent time getting my Z leveled to paper thin gap. Then I had the 9 point level fail as the bed hit the belt screw (Y). So I moved the bed over towards the home sensor. Next Z home and the hot end dug deep into the bed mat, deep channels cut. That sheet is toast. So I’ve readjusted Z home again...
0
4
121
deró
Apr 12, 2019
In Assembly
Installed the Dual touchscreen and Marlin, configured the solenoid to switch hot ends, then verified both extruders worked. While testing #2 extruder, the solenoid started to buzz and now it will no longer respond. Looks like it has failed, hopefully not the driver board.
0
0
68

deró

More actions