Thank you now my question is do I want to put in both high Temps or low or one of each I am not sure what to do is it based on the material or some other reason

I get it Thanks

@Makertech can we replace the red boards with the 2208 and 2130, if yes what settings should we use?

@Makertech was the z set differently?

Do you have any idea what the resister trim pot need to be set for the 2208 driver?

I forgot to mention that I am going to hot glue over the pins on the drivers so if the heat sink shifts toward the pins the hot glue will act as a stop, I am hoping the drivers don't get hotter that hot glue melting point