Forum Comments
Alu Bed levelling - Octoprint Bed Visualiser
In General Discussion
Error: checksum mismatch, last line: ****
In General Discussion
Must have plugin "OctoPrint Connection"
In Makertech CURA
Must have plugin "OctoPrint Connection"
In Makertech CURA
Heated bed corrosion
In Hardware Components
Error:Printer halted. kill() called!
In General Discussion
Lee Hamilton Cooper
Nov 29, 2019
Hi Dataris. Yes good suggestion! I did actually think of this a few days ago so I did actually check. But I think I’ve actually found the issue with the 2 x TMC2100’s not working. I had a new TMC2208 that was a spare so tried it, and it worked! I’ve now ordered another to replace the TMC2100.
0
Error:Printer halted. kill() called!
In General Discussion
Error:Printer halted. kill() called!
In General Discussion
Lee Hamilton Cooper
Nov 28, 2019
Hi Antony, The Z works fine, but wen I home a red alarm pop up box appears with the same error code that previously came up on the printer touchscreen. And the only thing that comes up on pronterface is: 23:04:37.844 : N16 G28*36 23:04:49.066 : Error:Printer halted. kill() called!
0
Lee Hamilton Cooper
More actions