@Akisame - Hi would you be willing to share what you have currently set up in Prusaslicer? I prefer Prusaslicer and I was planning on setting a standard profile up but I thought I would ask before I started tinkering! I would be really interested in your High Speed and High Detailed ones too when they are ready!

Thank you for making the Klipper config I am really interested in trying Klipper on my machine! I am just wondering what do you think is the best thing to use Klipper along side Fluidd, Octoprint or Mainsail?

@Frederik Weis In all honesty, I am not sure. I have compared the firmware you provided and my own and they are similar. I may have just unticked one thing but I did need to go back in as I had some issues with my Filament Sensor! I will be using Teaching Tech git hub too! I used it heavily with my Ender 5 and it helped me get good quality prints!

@Frederik Weis Managed to fix the issue needed to do a little bit of tinkering with firmware! But we are nearly at the point to print! Have you managed to set up a slicer to start printing yet?

@Frederik Weis I have done that, all are triggering but when it homes it just drives the bed in to the nozzle when though the LED is on.

@Frederik Weis Hi Frederik, Thank you for sending that over! That has fixed my issue with my inverted axis! Now I just need to figure out why my probe won't stop the bed when it should!

Hi Frederik, Just wondering if you have fixed the X, Y and Z Axis being inverted? I have the same problem and was wondering if it was a wiring issue or firmware? Cheers, Luke