top of page

Forum Comments

I can not get the first print to work, I can't even get a good base layer nothing sticks to the flex plate sticker.
In General Discussion
Nate Clark
Apr 14, 2020
I got 1 part to print by using a glue stick and now I have this iseue on X and Y miss alignment
Content media
1
0
I can not get the first print to work, I can't even get a good base layer nothing sticks to the flex plate sticker.
In General Discussion
Nate Clark
Apr 13, 2020
I will relevel again as I only have a single sheet gap now. I have a new issue as I tried running a new print and the X-axis crashed and broke the limit switch when I canceled the print when it didn't adhere to the bed. What can cause this?
1
0
I can not get the first print to work, I can't even get a good base layer nothing sticks to the flex plate sticker.
In General Discussion
Nate Clark
Apr 13, 2020
Hello, Thank you for replying. I currently have the Z height resting on the piece of paper. What is the correct height for the best result.
1
0

Nate Clark

More actions
bottom of page