Forum Posts

tom.messelis
Jul 24, 2019
In Assembly
Can't seem to figure out how to properly execute step 22 in the print platform installation. The issue I have is with the front eccentric spacers: If I tightern the M5 nuits, the platform can hardly move. If I loosen the M5 nuts a bit, the eccentric spacers are loose, so the platform 'dances' around a bit when moving. I tried this like 20 times, but I never get this ok. Any ideas on how to fix this is greatly appreciated!
0
1
40
tom.messelis
Apr 29, 2019
In Assembly
hi all, have an issue with the X-axis/bed. when moving it around on 1mm, it kinda goes ok, but when moving with 10mm it makes a rattling noise and the motor is clearly struggling. I can move the bed around manually (slight tension, although I'm not sure how much tension is ok?) what to do here? thanks
0
5
67

tom.messelis

More actions