top of page
Reurn to Forum Home
Forum Comments
Servo motor is no more working
In Dual Switching Hotend v1
Nicolas
Aug 28, 2019
Hello, Same for me. Upgrading the Proforge 2S with the DSE. It was working fine until stage 8, then it was no more able to turn to select the Hotend #1. I did the configuration again from the begining but it's not working anymore. So, should I just replace the servo or is there any workaround ? I sent two email to Makertech but still no reply so far. Thanks in advance.
0
0
Nicolas
0
Followers
0
Following
More actions
Profile
Forum Posts
Forum Comments
bottom of page