When testing homing Y. It makes loud noise as it move toward the y-endstop. Any suggestion?
Question
So i'm finally assembling my Proforge 2S. It's finally built and most thinfgs so far are ok but I am at the testing stage and having issues with Z axis. When I move the the gantry via the touchscreen it just goes down with both button presses and it rattles a lot. It seems like the up button is actually moving it downwards better while down just moves it slightly and/or gets stuck. The rattling sounds like drilling a wall. I thought some screws are lose but i rechecked everything and all seems fine. I also checked the jumpers and steppers. Jumpers are all in and if i understand correctly both TMC2100 steppers have to be set identical (unlike A4988). Please help someone :(
Can you pinpoint where exactly the noise is coming from?
Thanks for you reply I was able to trace the problem the the gantry belt being too tight.
Still making a noise when homing on the Y. Will upload a video.
OK, When back and double check Step 4 Y-Idler Install, notice that the 15mm washers was not pressing against the end of the beam. Corrected this error. It is not longer making a noise when Y is homing.