hansamann
Apr 6

Stage 11 Makertech Cura

1 comment

I've downloaded Makertech Cura via the link the tutorial, it was not 7Z, it was a normal dmg file and I was able to open that dmg and put the Cura app into applications.

 

Upon opening my MacOS 10.14.4 complains it is damaged and recommends to move it to trash. Is the Mac version broken? Anyone had the same issue, are there ways to fix this?

hansamann
Apr 6

All right, this error is described in the docs a few lines down... sorry for that.

0
New Posts
  • Mark Perry
    Oct 12

    No Connection or lights when connecting to USB

    Hi, I am attempting to complete Stage 10 Step 7. When I connect the control board to the computer USB port, I don't get any lights and the port doesn't show up in Arduino. I have tried 2 different computers, I have also tried connecting directly with the blue cable into the control board, rather than through the extension cable. With the same result. No lights showing. Directly connected and no lights. If anyone has any ideas I would appreciate trying them.
  • xecaz
    Sep 30

    Missing temp readings and heat on extruders and bed

    I am building the Proforge 2S with dual extruders and the heated bed upgrade and at stage 10, step 15 (https://makertech-3d.dozuki.com/Guide/Stage+10+-+Programming/15?lang=en) i see all 3 icons(heated bed, and both extruders) but only Extruder 2 shows the correct ambient temprature. Extruder 1 shows -15c and the heated bed show 166. To verify that the thermistors are working i tried to connect each and every one of them to the Extruder 2 pinout on the board and they all show their respective ambient tempratures, confirming that the thermistors work individually. However no matter what thermistor i connect to the other 2 connectors on the controller, i get no other reading. Do i have to enable something in the arduino code to enable the other ports on the controller? Someone suggested to swap the polarization of the sensors, but this left me with the same result. Additionally preheating the bed or any of the extruders does not change their temprature (using my fingers to feel if they get warm). I measured the powersupply and see good voltages. Has anyone else ran into this?
  • FM
    Sep 9

    Dead servo

    Look like I've got a dead servo. Tests failed on DSE Stage 07 - Switching Arm and Z-Offset I'll arrange for a replacement.