Hi all, as soon as I hit connect on Pronterface I'm given this error:
Connecting...
start
Printer is now online.
echo:Marlin 2.0.5.3
echo: Last Updated: 2020-03-31 | Author: (none, default config)
echo:Compiled: Aug 8 2020
echo: Free Memory: 3141 PlannerBufferBytes: 1232
echo:EEPROM version mismatch (EEPROM=? Marlin=V76)
echo:Hardcoded Default Settings Loaded
Testing X connection... Error: All LOW
Testing Y connection... Error: All LOW
Testing Z connection... Error: All LOW
Testing E connection... Error: All LOW
Testing E1 connection... Error: All LOW
And after clicking any of the home icons I receive:
echo:busy: processing
echo:busy: processing
echo:busy: processing
echo:busy: processing
echo:busy: processing
Error:Printer halted. kill() called!
[ERROR] Error:Printer halted. kill() called!
I'm kinda new to 3D printers, AXIS 3D being my 2nd, so sorry if I sound dumb. I've followed the tutorial as well as I could, installing the Firmware following Stage 9. As well, the X-axis does not seem to want to move, despite being able to move it by hand with no resistance. The only addon I've got is the heated bed.
Any suggestions would be greatly appreciated.
TMC2208's or the A4988's? Make sure you have the board in either UART mode or step/dir mode by having the jumpers in the correct place.