1. The hotend 2 red wires and white thermistor wires are nowhere near long enough and I definitely have the wire pulled through the webbing correctly.
2. The hotend fan cable has a white attachment on the end so I need advising if to cut this off so that I can join the wires with the others or not?
3. I have 2 extruder motor cables and only one is described in the instructions, so where does the other one plug in?
4. I only have 1x 1m motor cable left instead of 2 x50cm motor cables that I need to connect the 2 motors underneath the base.
IMG_20200728_175303
.jpg
Download JPG • 3.92MB
IMG_20200728_175023
.jpg
Download JPG • 3.54MB
IMG_20200728_175042
.jpg
Download JPG • 3.91MB
IMG_20200728_175120
.jpg
Download JPG • 5.50MB
IMG_20200728_175122
.jpg
Download JPG • 3.48MB
I have taken photos that correspond to these problem if you can provide me an email address to send them.
Thanks,
Second extruder cable plugs into the E1 position, it is the port next the first extruder position.
Ah, I see, you can use this form here and we'll get another cable out to you, check you've got everything else too, that way we can send it all together.